Skip to content
SafetyCulture
Template

Fall Protection Site Safety Inspection

by SafetyCulture

Free
Downloads: 291

Perform this checklist to identify safety measures before, during and after work shifts. Start with a description of the work, take photo of it and list down names of personnel performing the task. Next identify the safety measures which include permits, proper training, safety routes, vicinities and equipment. Then check the harness if it is properly connected and used. Afterwhich, Identify the changes that needs to be implemented and finally, summarize the inspection by providing recommendations of equipment to be replaced or remove from service.

About author

Free 1,000+ Workplace Checklists & Templates created by the SafetyCulture team.

You might also like

  • Confined Space Pre-Entry Inspection
    SafetyCulture logo
    Template

    Confined Space Pre-Entry Inspection

    Use this checklist before entering a confined space. Start by filling out general information about the confined space, its type, how often it is used, and the work to be performed inside. List down names of the people involved in the work and classify if it is permit-required or not. Next check if the area is free from hazards and ensure that the atmosphere is tested carefully. Evaluate if the workers are competent and trained to perform the job and if proper protective equipment (safety harness and lifelines) are worn properly. Lastly, ensure that permits are posted in the entrance of the confined space and show the names of the persons qualified to perform the job. Complete the audit by citing any safety recommendations.

    by SafetyCulture
    Downloads: 348
    Get
  • Safety Harness Inspection
    SafetyCulture logo
    Template

    Safety Harness Inspection

    Use this template to ensure that your harness is in good condition before use to reduce the risk of falling. Begin with providing a description about safety harness usage then attach a photo of it. Carefully inspect each part of the harness and its connections (snap hooks, lanyard and tie-off adaptors/anchorages). Make sure to check the label of each to identify the type of harness, model, manufacturing details, limitations and warnings. Complete the inspection by rating the overall condition and providing recommendations to improve safety.

    by SafetyCulture
    Downloads: 1,974
    Get
  • Welding Safety Checklist
    SafetyCulture logo
    Template

    Welding Safety Checklist

    Use this checklist before commencing welding tasks. Start by taking a photo of the work area and check if the operator has undergone proper training, understands instructions, and wears appropriate PPE. Next, evaluate if equipment is in good working condition and the working area is ventilated and free from flammables and obstructions. Inspect if procedures were followed during and after work. End the report by by providing recommendations and an overall safety rating.

    by SafetyCulture
    Downloads: 1,177
    Get
  • PPE Checklist
    SafetyCulture logo
    Template

    PPE Checklist

    This PPE Checklist can be used by managers and safety officials to identify sources of hazard and select the appropriate equipment. Start by recording nature of work and potential hazards that may be in contact with body parts. The template then prompts the inspector to describe the hazard,state the required PPE and check the condition of the PPE by capturing photo evidence. Lastly, it summarizes the inspection by providing recommendations.

    by SafetyCulture
    Downloads: 2,569
    Get