This GPO shop testing checklist guides technicians through pre-deployment verification of audiovisual and control systems. Confirm rack and room labeling, record serials, MAC addresses, and IP details, and ensure all cables match drawings. Verify external gear in lectern whips, update firmware on Crestron devices, and load DMPS configuration. Check codec firmware, disable Voice VLAN and Touch10 where required, and load control code to the processor and GUI to the touch panel. Set accurate time, then test video and audio from all sources including multiple microphones. Validate routing, presentation via touch panel, codec and camera control, relay behavior, master and conferencing volume, and room mic controls. Confirm help information, blank display, startup and shutdown behavior, occupancy sensor automation, shutdown timeout, and perform power down and retest.
With SafetyCulture you can
With SafetyCulture you can
About author
This community page makes available free workplace checklists and templates created by other users within the SafetyCulture community. SafetyCulture has re-published this content and where possible, has credited the original author. SafetyCulture has not verified the accuracy, reliability or suitability of any community content. You agree that your use of any of this content is in accordance with SafetyCulture’s Terms and Conditions .