Skip to content
SafetyCulture
Template

CCTV FAT Test Checklist for Tram Systems

by Ben Goh, from the Community

0
Get this template

This Factory Acceptance Test checklist is designed for tram CCTV systems. It guides technicians through pre checks, ADAMS device voltage validation, relay light verification, driver display checks, camera cycling and numbering, image quality review, Genetec driver monitor behavior during wire disconnect and reconnect, door interlock logic, camera disconnection alarms on Klipstation, OCMS fault simulation, and confirmation of GPS and 5G connectivity and correct tram naming in Genetec. Use it to confirm system performance and readiness before commissioning.

With SafetyCulture you can

Digitize any process, procedure or policy
Eliminate mistakes made by paper-based processes
Create and share professional reports instantly
Confirm accountability and compliance with a digital log

With SafetyCulture you can

Digitize any process, procedure or policy
Eliminate mistakes made by paper-based processes
Create and share professional reports instantly
Confirm accountability and compliance with a digital log

About author

Community

This community page makes available free workplace checklists and templates created by other users within the SafetyCulture community. SafetyCulture has re-published this content and where possible, has credited the original author. SafetyCulture has not verified the accuracy, reliability or suitability of any community content. You agree that your use of any of this content is in accordance with SafetyCulture’s Terms and Conditions.